31
ARMASIGHT by FLIR
COMMAND
U S E R M A N U A L
SEQ
NO.
LOCATION OF
ITEM TO CHECK/
SERVICE
PROCEDURE
NOT FULLY MISSION
CAPABLE IF...
16
Remote Control Turn the equipment to standby. Point the
equipment at an object. Push and hold the
remote control button. Look for a thermal
image on the display. Release the button. Turn
off the equipment.
No image.
17
Video Cable
Connect an external monitor to the Command.
Point the equipment on an object. Turn the
equipment on. Look for an image on the
monitor. Turn off the Command. Disconnect
the monitor.
No image.
POST-CHECK PROCEDURES
Turn off the equipment.
Replace the objective lens cap.
Remove the batteries.
Return the equipment and all accessories to
the carrying case.
4.2 OPERATOR TROUBLESHOOTING
The purpose of troubleshooting is to identify the most frequent equipment malfunctions, probable causes,
and corrective actions required.
Table 4-2 lists the common malfunctions that may be found during the operation or maintenance of the
Command. Perform the tests/ inspections and corrective actions in the order listed.
This table does not list all of the malfunctions that may occur with your device, or all of the
tests and corrective actions that may be necessary.
If you experience an equipment malfunction
that is not listed, or is not fixed by the corrective actions listed in the table, please contact Customer
Service center.
TABLE 4-2. OPERATOR TROUBLESHOOTING
MALFUNCTION
PROBABLE CAUSE/ TEST/ INSPECTION
CORRECTIVE ACTION
The Command fails to
activate.
Batteries are missing or
improperly installed.
Insert batteries or install correctly.
Batteries are dead.
Replace the batteries.
Batteries, surfaces, or contacts
are dirty or corroded.
Clean the contact surfaces with a pencil
eraser and/or alcohol and cotton swabs.
Remote control unit is damaged.
Please contact Customer Support.
Remote control battery is dead.
Replace the battery as per Part 4.3.4.
The equipment is damaged.
Please contact Customer Support.
TABLE 4-1. CONTINUED
