PDS-32/42/46/47/52/55
www.
Armagard
.com
Installation Manual Page |
11
Toll Free (US):
1-866-434-0807
Call (UK):
0121-608-7210
The printed circuit board (PCB) automatically manages the on-off commands for an
enclosures air curtains and fans, heaters, and media off switch. To reconfigure the controller
board, you’ll need the setup kit which is provided by Armagard as an optional extra.
All controller boards are automatically set-up with default temperatures (below), if you want
to change these settings then follow the below instructions.
Defaults: Fans on @25°C, Heaters @10°C, Media off (high) @42°C and (low) @0°C
Defaults: Fans on @77°F, Heaters @50°F, Media off (high) @107.6°F and (low) @32°F
NOTE: Not all units are equipped with a controller board. If your unit is not equipped with a
controller board, then it will use automatic thermostats instead. Details on how to use the
thermostat are found in the maintenance section (Pg14).
Kit Needed:
Armagard USB Cable
Armagard USB Drivers
Windows 7 Laptop
Phillips Screwdriver
Directions:
1.
Locate your Armagard USB cable and terminal software, and have them placed to
one side.
2.
To configure the PCB you’ll need a computer (ideally a laptop) which will be close
enough for the USB cable to reach.
3.
Place the terminal software on your computer, if you’re running a Windows 7
computer then the drivers should be automatically installed. If not, then install the
CP210x drivers and select the appropriate 32bit or 64 bit driver. Make note of the
‘Terminal’ icon which we’ll come back to later.
4.
Once the drivers are installed, you then need to locate the controller board within
your enclosure (figure 1).
NOTE: Make sure the enclosures power is switched off and
unplugged before removing the cover to avoid a risk of an electric shock.
Figure 1
CONTROLLER BOARD SETUP
