Arjohuntleigh Minuet 100500AUS, Руководство пользователя

Страница: 7 / 16

7 AH-MIN V3 08 / 10 /17
9. Carefully thread the foot end actuator cable through the support loop (G) on the deck frame and
connect it to socket 4 on the backrest actuator/control box. Adjust the cable coils in the loop so the
cable is under tension but not strained..
10. Connect the control handset cable to socket 1 on the backrest actuator or control box. Clip control
box cable retainer in position and replace backrest sheet metal top.
11. Stand the bed on its castors. Assemble the other 3 clamp screws in the underside of the remaining
side rail tube. Make sure all joints are fully inserted and tighten all 3 remaining clamp screws firmly
using supplied Allen key.
WARNING
DO NOT use the safety side rails to lift or move bed.
WARNING
Make sure that the mains supply cable is not stretched when connected.
Make sure that the handset and mains cable cannot become entangled with
moving parts of the bed.
Lower the bed to minimum height and disconnect the bed from mains power supply.
On both the head and foot end column assemblies, turn the castors inward toward each other and
apply the brakes.
Turn the bed on one side. Disconnect the control handset from the socket on the backrest actuator
or control box. Disconnect the actuator cables from the sockets on the backrest actuator or control
box and remove cables from the support loops on the frame.
Loosen two clamp screws and remove the foot end column assembly.
Loosen two clamp screws and remove foot end column deck assembly.
Loosen two clamp screws and remove the head end deck assembly from the head end assembly.
4.
Disassembly
— All Models
G
F