Arjohuntleigh 507003, Руководство пользователя

Страница: 16 / 36

10
6. Troubleshooting
The
Flowtron Universal
pump features an audible and visual alarm. If a problem
occurs, the system will sense the fault and briefly flash a message on the display.
If the same fault continues for 10 successive inflations (up to 10 minutes), the audible
alarm will sound, the red alarm lights flash and a message will appear on the display
until corrective action is completed. (The exception to this is an “F” fault, which will
alarm immediately.)
Alarm Cancel:
After a fault has been corrected, the alarm can be cancelled by two methods:
Press the RUN button twice, or until the green lights are lit and the pump is
running.
Refer to “Battery Operation” on page 13 when operating the pump under
battery power.
With the exception of a pump failure ( F ), correct the fault and allow the pump to
run until it senses a normal inflation; it will then reset itself.
Recommended Checks:
To confirm that the fault has corrected, watch the display for approximately one
minute. If the fault has not been corrected, a fault message will flash during that
time.
In addition, the pump will refuse to start if it does not recognize the attached garment.
Pump Display Problem Corrective Action
Lo Garment leak Garment Leak Check garment and replace if
faulty.
Lo Garment disconnected Garment disconnected Check and reconnect.
Lo Garment loosened Foot Garment has come off
patient during use Reapply foot garments to
patient.
HI Tube kinked Hose kinked causing a blocked
tube Check hoses for kinks and
obstructions.
F Pump fault Pump failure Do not use pump, refer to
service.
Pump Display Problem Corrective Action
“None” or
“Standby Attach Garments” Pump will not start due to no
garments connected or a non-
Huntleigh authorized garment
connected. Connect an authorized
Huntleigh garment.