Page | 5
Commercial in confidence. User Manual
POBT-REV4-241019
3. ASSEMBLY
– (continued)
3. Place Top Frame assembly face down onto a carpeted or similar protective surface
in order to prevent damaging or scratching the top.
4. Secure the outer column to the top frame assembly using four M8 x 15 cap screws
and M8 ID washers – refer figure 4.
5. Whilst the overbed table is in the upside-down position, carefully loosen off and
remove the column compression retaining screw shown on
figure 2
and allow the
column to fully extend. Be sure no person is leaning over the overbed table when
carrying out this procedure.
6. With the aid of a second person turnover and place the overbed table on to its four
castors.
7. Check for correct and smooth operation and that all fixings are secure.
8. Wipe over clean as per cleaning instructions (page 7).
Top frame
Column
Figure 4.
Caution
Split tops only; take care not to allow the main (hinged) top to swing away
from the frame as this could damage the mechanism and cause injury.