How to Use the KWIKtrak Turntable
10
001.1
1720.EN rev
. 13
Automatic KWIKtrak Turntable
Operating the Turntable
1) Make sure the lift is powered.
2) Move the lift into the turntable and release the
button on the hand control. Wait for the beep
sounds. The turntable will rotate to the next
position.
3) Move the lift out of the turntable along the new
path.
4) If the turntable fails to operate automatically or
in an emergency situation, manually rotate the
turntable after sliding and holding the quick-
release button in the open position
(see Fig. 4). Take care for not getting injured.
Fig. 4
Manual KWIKtrak Turntable
Operating The Turntable
1) Move the lift into the center of the turntable.
2) Make sure that the lift is centered with the
turntable, then pull the Turntable’s shortest
cord until the pivoting track is aligned with the
next position.
3) Move the lift out of the turntable along the new
path.
4) In case of a malfunction, pull down the
activation arm, to unlock the pivoting track, and
rotate the track manually. Take care for not
getting injured.
Adjusting Pull Cord’s Length
If the pull cords are too long, they may be
shortened as follows.
1) Turn the mechanism halfway so that both
cords are of equal length.
2) Cut both cords to equal length making sure
that you leave at least 20 cm (8 in) on each
cord.
3) Insert one knob on each cord and secure it
with a double knot.
Fig. 5
CAUTION:
Pay attention to pull cords, when
moving the ceiling lift onto or out of the
turntable, to make sure they do not get
entangled.
Note:
The mechanism may block if the ceiling
lift is not centered under the Turntable before
pulling the cords.
Shortest possible length
͑͑͑
20 cm
Can be cut anywhere
within this range
Cut both cords equal
when Turntable is
turned halfway
How to Use the KWIKtrak Turntable
