arietta PRO001MX 30, Инструкция по использованию и уходу

Страница: 16 / 47

16
making the electrical connections:
wARNING
Electrical Shock hazard
warning: Turn off power at the service panel before wiring this unit.
10 VAC, 15 or 0 Amp circuit required.
IF hOUSE wIRING IS NOT A wIRE INSTALLATION (NEUTRAL, LINE AND GROUND), A GROUND mUST BE PRO-
VIDED By ThE INSTALLER. whEN hOUSE wIRING IS ALUmINUm, BE SURE TO USE U.L. APPROVED ANTI-OXI-
DANT COmPOUND AND ALUmINUm-TO-COPPER CONNECTORS.
ELECTRICAL GROUNDING INSTRUCTIONS. ThIS APPLIANCE IS FITTED wITh AN ELECTRICAL JUNCTION BOX
wITh wIRES, ONE OF whICh (GREEN/yELLOw) SERVES TO GROUND ThE APPLIANCE. TO PROTECT yOU
AGAINST ELECTRIC ShOCK, ThE GREEN AND yELLOw wIRE mUST BE CONNECTED TO ThE GROUNDING
wIRE IN yOUR hOmE ELECTRICAL SySTEm, AND IT mUST UNDER NO CIRCUmSTANCES BE CUT OR REmOVED.
Failure to do so can result in death or electrical shock.
• Remove the j-box cover as shown in below picture.
• If not already done, install 1/2” conduit connector in j-box.
• Run black, white, and green wires (#14 AWG) according to the National Electrical Code or CSA Standards and local
codes and ordinances.
• Connect black, white, and green wires from power supply to black, white, and green/yellow wires in j-box respectively.
• Close j-box cover.
Power supply conduit
Junction box
Connecting the ductwork
•
Install ductwork, making connections in the direction of airflow as illustrated.
•
Push duct over the exhaust outlet.
•
Wrap all duct joints and the flange connections with duct tape for an airtight seal.
•
Make the same connection in the wall or ceiling vent exit.
Final installation steps
•
Install grease filters as described in the Use & Care section of this manual.
•
Turn power on at service panel.
• Check operation of the hood.
���� ����
���� ����
�������
Installation Instructions