arietta PRO001MX 30, Инструкция по использованию и уходу

Страница: 15 / 47

15
Installation Instructions
wall mount Installation
wARNING - The following instructions are intended for drywall only, please note that when installing to concrete/masonry
additional wall fastener anchors (not provided) shall be used
Note: see below if cabinet installation is preferred
. After the hood installation height has been determined draw a horizontal line at a distance above the cooktop equal to the
desired hood installation height plus 10”.
5. Find the centerline of the cooktop. Draw a vertical line along this centerline up to the horizontal line drawn in step 1 and
draw a vertical line right and left at a distance of 11-59/64" (for 36" model) or 8-15/16” (for 30" model) to determine the
mounting location of the mounting hooks shipped with the hood.
6. Fit two mounting hooks on the wall to hang the hood through the provided slots
(2 hooks + 2 screws 5x35).
7. Run 8” Duct , long enough to reach the transition once the hood has been installed plus
1 1/2” inch to connect ductwork. Fix Duct to transition with screws and seal with tape.
8. Remove 1 of 2 knockouts and install 1/2” conduit connector in j-box.
9. Hang the hood and adjust its position through the screws on the hooks.
10 .Fix the hood to 4 additional point,2 on upper side, 2 on lower side (use 4 w 4 screws 5x35.
Cabinet Installation:
. Find the centerline of the cabinet bottom. Draw a line along this centerline from rear to front of the cabinet.
5. Draw two lines, one at a K distance from the wall, the other one at a Z distance from the previous line.
Mark 4 points , two along each line at a distance of half W from the center line, to determine the screw locations.
6. Fit 4 screws on cabinet bottom do not tighten completely but leave a space of about 1/2” from cabinet bottom surface
and head screws.
7. Run 8” Duct , long enough to reach the transition once the hood has been installed plus 1 1/2” inch for connect ductwork.
8. Remove 1 of 2 knockouts and install 1/2” conduit connector in j-box.
9. Hang the hood on screws through side slots provided on hood top.
Tighten the four screws.
Note: If possible fix the hood on the wall at 4 additional point (2 on upper side, 2 on lower side).
10.From the inside of the cabinet attach the transition on upper outlet.
Fix Duct to transition and seal with tape.
11
59/64
“ 11
59/64
“
10“
7/16“
8
13/16
“
W
Z
K
8
1/4
“
18 “
8
15/16
“ 8
15/16
“
10“
7/16“
8
13/16
“
W
Z
K
8
1/4
“
18 “