EN - 12
9. Insert bagger support (item 19) through
the opening and between left support
bracket and frame. Ensure that hinge
plates are positioned facing the rear. See
Figure 9.
10. Attach bagger support with one
1/2"-13 x 3 1/4” hex bolt (item 21), one
1/2"-13 x 3" hex bolt (item 20) and two
1/2"-13 top-lock flange nuts (item 22).
Fully tighten hardware. See Figure 10.
11. Reinstall plastic hex screws retaining left
fender.
Install Right Bagger Support
1. Clean surface thoroughly and attach one
transmission disconnect decal (item 35)
to right-side support bracket (item 7). See
Figure 11.
2. Remove 1/2" x 1" bolt and hex nut
retaining spacer plate and remove plate.
Discard bolt, nut and spacer. See
Figure 12.
Figure 9
Hinge
Plates
19
Figure 10
20
21
22
22
Figure 11
35
7
Figure 12
Spacer Plate
