Argus RSM 48/10, Руководство пользователя

Страница: 4 / 38

Specifications for Argus’ RSM 48/10 Top Input/Output 19" Shelf for 30A System
Argus Technologies Ltd. 030-692-B1 Rev A WC
Printed in Canada. © 2006 Argus Technologies Ltd. ARGUS is a registered trademark of Argus Technologies Ltd. All Rights Reserved. Page 1 of 2
System Output (Three Power Modules)
Voltage: 42 to 58Vdc
Current: 30A nominal
Power: 1650W continuous
Heat Dissipation (240Vac): 696 BTU
Power Module Output
Current: 10A nominal/module (13A maximum)
Static Regulation: -1% load (with slope) ±0.1%
<0.04% line
Dynamic Regulation: <1% deviation for 50 to 100% load step
Response Time: <2ms to 0.1% of output for 50 to 100% load step
Time Stability: 0.1% per year
Temperature Stability: <100ppm per degree C (0.01%) over the operating range
Noise: <26dBrnC (<22dBrnC with battery)(voice band)
<10mVrms, 10kHz to 10MHz (wideband)
<150mVp-p, 10kHz to 100MHz
EMI: The unit meets the requirements of:
ICES-003 Class B
FCC Part 15, Class B
EN 55022 Class B (240)
EN 61000-4-2 (240)
EN 61000-4-3 (240)
EN 61000-4-4 (240)
EN 61000-4-5 Class 4 (240)
Fuse Type/Rating: Fast acting, 1/4 x 1-1/4”
15A, 60Vdc
Isolation Resistance: 10 mega ohms
In accordance with FCC requirements, we provide the following statement as specified in the FCC guidelines for
conformance to Part 15, Class B:
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications to this equipment not expressly described in this manual could void the FCC
compliance.