Issue 1 25/2/2019
5
6. Using the point of a brad awl or screwdriver, make a small hole in the
centre of the cable grommet and feed the cable and insulation through
the grommet (fig. 4).
7. Check the fixing bolts are still in position, before securing the back
plate to the wall using the screws supplied (fig. 4).
8. Ensure that gasket is in position and make the electrical connections
(fig. 5) - see section
‘Connecting to the mains supply’.
9. Ensure that the gasket is fitted onto the rim of the back plate and refit
the terminal block. Carefully arrange wires into the back plate recess.
Align the holes in the mounting plate with the bolts and secure the
light fitting refitting the two domed cap nuts (fig. 6).
10. Fit a suitable bulb (not included) into the lantern (fig. 8 & 9)
– see
section
‘Bulb replacement’.
11. Reconnect to the mains supply.
Note:
If fixing to timber surfaces, use a drill bit suitable for wood and do not
use the wall plugs.
Fig. 4
Fig. 5
Fig. 6
Fig. 7
