Subject to change · Filter and recirculating pump unit UMPC 045 Light Line· 0119 · EN
Page 18
www.argo-hytos.com
9. Service
9.1
Switching on the device
To turn the unit on, press the ON / OFF switch.
9.2
Data collection
The OPCom sensor installed in the UMPC 045 Light Line is equipped with a data memory which internally stores up to 3,000 results.
When the memory capacity has been reached, the last measured value is stored and the oldest measured value is overwritten.
NOTE
A description of the installation and data transmission can be found in the OPCom user manual.
In the front panel of the UMPC 045 Light Line unit there is a serial interface (fig. 5, page 13) via which the OPCom Particle Monitor
can be read out and configured. For this purpose, a PC and an appropriate terminal program or a readout software is needed. The
sensor has to be connected to a free COM port of a computer. A suitable communication cable for serial connection between sensor
and computer / controller is described in Chapter 21("Accessories") of the OPCom manual. If the computer does not have a serial
COM port, it is possible to use a USB-serial converter.
NOTE
The software can be downloaded from www.argo-hytos.com.
The stored results are transferred to the connected devices such as PC, laptop, tablet or smartphone and can be stored there.
