16
Switching the light on/off
Press the ON/OFF button quickly to turn the front light (and rear light, if applicable) on and off.
Viewing data (AVG - MAX - TRIP - ODO)
The data available on speed (AVG and MAX) and distance (TRIP and ODO) will be displayed alternately and automatically in
sequence: AVG - MAX - TRIP - ODO.
The partial usage data (TRIP - AVG - MAX) will automatically reset after the display is turned off.
Indicator light for residual battery charge
The battery charge level is shown on the display screen as a number of dashes between 0 and 5.
If there are 5 dashes, it means that the battery is charged to the maximum percentage defined and detected instantly.
Less dashes are shown to indicate a decrease in the battery charge level available and subsequent autonomy.
The level of the battery charging indicator may fluctuate depending on how the electrically power assisted cycle is being
used, for example, when going up a slope, the level displayed can drop rapidly as there is a much higher battery consumption.
The individual dashes indicate the specific battery charge range detected at the time and do not necessarily indicated a
percentage of the residual autonomy.
Malfunction indicator light
If a malfunction of the bike’s electrical and/or electronic system is detected, the relevant warning light will appear on the
display screen and the relevant identification Error Code will be displayed at the same time
Error Code
Malfunction description
2
Malfunction when using the walk assist mode lever
3
Brake sensor malfunction
4
Control unit malfunction
7
Control unit overtemperature
8
High voltage protection (voltage above threshold)
10
Motor malfunction (excessive power consumption)
11
Motor hall sensor malfunction
17
Display-control unit wiring communication malfunction
18
Display-control unit programming communication malfunction
19
Brake sensor malfunction
20
Motor block
Parameter configuration
Press the M button for at least 3 seconds to access the configuration menu and then, quickly press the M button to confirm
the data entered and display the next parameter to be configured.
Select the value for the individual parameter by pressing the + or - buttons and confirming it by pressing the M button (quickly
to access the next parameter).
The sequence of parameters that can be configured is shown below:
P1 - Unit of measurement:
Press the + or – buttons to select the unit of measurement for the speed and travel data displayed on the display: International
metric system (Km/h and Km) or British imperial system (MPH and Mile)
P2 - User password ON/OFF display:
Available options = on / off
OFF = selecting “off”, confirmed by pressing the M button, excludes the user password request (identification code) to allow
the user to access and activate the display and allow full control of all the functions provided for the electrically power
assisted cycle.
The display controls and functions will be immediately accessible after pressing the ON button.
ON = by selecting the data "on", confirmed by pressing the M button, the configuration parameter is enabled which provides
for the activation of the display and access to all the functions provided for the complete management of the pedal-assisted
bicycle exclusively after entering a user password (identification code).
Display controls and functions, after pressing the ON button, will only be accessible after entering the user password previ-
ously set (P3).
Содержание BiMax XL
Страница 1: ...English Italiano Polski e bikes user manual ...
Страница 2: ...01 English 02 Italiano 29 Polski 56 ...
