Original User Manual
–
A
REBO
S SPA Pool
13
3.4 Fill the spa pool with water
•
Make sure the power cord is outside the pool and is not connected to the power supply.
•
Screw the filter cartridge onto the water inlet of the whirlpool wall by turning it clockwise.
•
Fill the whirlpool with a garden hose until the
water level printed on the whirlpool wall is
reached.
•
Do not fill up too much water, because the
water level will still rise when people step
into the pool.
•
Do not use rain or surface water.
•
Do not use seawater or salt water.
3.5 Connect the spa to the mains
•
Warning!
Observe the regional regulations (in case of doubt, please contact your power supply
company or your qualified electrical contractor).
The connection to the power supply requires a permanent connection to its own
power group that is not shared with any other appliances. This power group must be
fitted with a 16A fuse and the circuit must have an RCD (30 mA).
Do not connect the pool to the power supply if it is not filled with water.
•
Caution!
This pool is equipped with a plug fitted with a residual current device or
ground fault circuit interrupter (RCD). In the event of a leakage current, the power
supply is automatically interrupted to protect you from an electric shock.
•
Make sure that the device works properly by running the following test sequence:
- Insert the power plug directly into the fixed socket.
- Press the RESET button, the operating display should now light up.
- Press the TEST button, the operating display should now go out.
- Press the RESET button to use the device.
•
Do not use the device if the above testing sequence has failed. If that happens, switch off the
device and contact the manufacturer or a professional electrical contractor.
•
The plug must be pulled out of the socket to disconnect the device from the power supply.
•
The ambient temperature should be between -25°C and 40°C.
•
The device must not be used in the vicinity of a strong magnetic field.
•
The device must not be dropped or exposed to moisture.
ATTENTION!
Make sure that the filter is not
screwed on too tightly as this can
cause a loud noise and/or cause the
temperature gauge to fluctuate.
