•
After you connected all the wires of the seconds group, you should have a result that looks like
this:
•
Turn the clock on, and you should now see the seconds counting correctly.
•
Complete the other groups in the same way, keeping the cathode connection colors and the order
in which you connect them the same.
•
At the end of the connection process, we want to “loom” the wiring. This involves binding and/or
plaiting the wires to make them regular. For this you will need to disconnect the wires from the
board. Make a note of the colors of each of the cathodes and anodes, because we will need to
reconnect them in the same way.
•
I usually plait the 6 anodes together in 3 groups two wires each, and the 10 cathodes in 5 groups of
two wires. 3 plaiting and 5 plaiting can be found on YouTube. It is optional to plait the wires and
simply binding them gives a good result as well.
Содержание nixie v41
Страница 1: ...Arduino Nixie Clock v41 Operating Instructions Construction Manual Document V0041a...
Страница 12: ...Schematic Below is the schematic for the clock...
Страница 16: ...At the end of the low voltage circuit build your board should look like this Low Voltage Circuit...
Страница 19: ...At the end of the high voltage circuit build your board should look like this High Voltage Circuit...
