General
The clock has different modes of operation, which you select using the pushbutton. When you start the
clock up th very first time, it will start in “Time Display Mode”. We set it up to be the right time for where
the clock is being shipped to, so in the best case you will not even need to set the clock the first time!
The other modes of operation are described in the following sections.
Safety
The voltages produced in the High Voltage circuit can reach peaks of 400V! Take precautions not to
electrocute yourself! If you are not sure what this means, please do not use this clock and return it for a
full refund.
A shock from the clock high voltage circuit is at least a nasty bite. At worst it can kill you.
We decline any responsibility in the case of injury or death.
REPEAT
: If you are not sure, please do not use the clock.
Powering Up
When you power the unit up, it will display “88:88:88” for several seconds. This is for the calibration of the
High Voltage Generator to match the power adapter you have attached. During this time you might hear
some faint crackling noises from the generator. This is normal.
After finishing the calibration, the version number (“00:35:07”) will be displayed for about a second. The
clock will then go into normal operating mode.
Содержание nixie v41
Страница 1: ...Arduino Nixie Clock v41 Operating Instructions Construction Manual Document V0041a...
Страница 12: ...Schematic Below is the schematic for the clock...
Страница 16: ...At the end of the low voltage circuit build your board should look like this Low Voltage Circuit...
Страница 19: ...At the end of the high voltage circuit build your board should look like this High Voltage Circuit...
