ARDISAM
6
UNPACKING AND ASSEMBLY
Section Checklist
❑
Unpack Tiller
❑
Complete and Return Registration Form
❑
Install the Drag Stake
❑
Attach Throttle Lever and Cable Assembly to Handlebar and
Connect Cable to Engine
❑
Attach Handlebar to Tiller
❑
Attach Throttle Cable and Control
❑
Adjust Throttle Control Autochoke and Kill Functions
❑
Attach Shift Lever Rod
❑
Fill Engine Crankcase
Your rototiller comes fully assembled except for a few parts
which are described below. The following instructions will
help you unpack your tiller and assemble and adjust the tiller's
drag stake, throttle lever and cable assembly, handlebar, and
shift lever rod. You will need a screw driver, a 1/2" and a 9/16"
wrench, and a rubber mallet or wood block and hammer.
Air Cleaner
Recoil Start
Serial Number
Belt Guard
Detent Pin
Drag Stake
Wheel Lockout Butterfly
T-handle Throttle Control
Shift Lever Rod
T-clamp
The right and left sides of your
rototiller are determined from
the operating position as you
face the direction of forward
travel.
IMPORTANT
