ARDET ORIX 70, Руководство по эксплуатации

Страница: 38 / 56

Pag.
38
OPERATING INSTRUCTIONS
ORIX 70
TOOLS NEEDED FOR INSTALLATION
Tools not included in tool kit:

n.1 digital or analogical multi-meter (VAC – A. –mA. dc – Ohm)

n.1 small screwdriver for electrical connections..

n.1 medium-seized screwdriver.

n.1 cross screwdriver.

n.1 clamping pincers.

n.1 series of halon wrench.

Terminals which match the size of the wires. ( 1mm. – 1,5 mm. – 2 mm. – 4 mm. – 6 mm.)

Approvated cable ties

Series of straight exagonal wrench
MOUNTING PROCEDURE
1)
Place the base on the floor with the holes facing upward.
2)
Screw the wheels and tighten the nut
3)
Mount the column on the central base, ensuring that the control unit is facing the opposite side to the
two legs of the base.
4)
Block the column on the central base, tightening the nuts with the wrench
5)
Place the assembled column/plate on the wheels and connect the three wires with the female FASTONs
coming from the column with the correspondent three wires with male FASTONs coming from the
double counterbalanced arm.
CAUTION!
Carefully observe the color connections:

green/yellow (earth protection) with the correspondent green yellow wire

blue wire ( line)
with the correspondent blue wire

brown wire (neutral) with the correspondent brown wire
6)
Insert the hub of the spring balanced arm on the pivot of the column by letting the connection
cable run into the pivot.
7)
Check the lubrication of the pivot and if the case may be, pass a slight layer of grease.