arcweld 210C MIG, Руководство оператора, Страница: 20 / 31

E-1
OPERATION
E-1
1 M/min light 2 Amp light 3 Current display 4.Amp/WFS knob
5 Euro torch socket 6 MIG polarity connector 7 Negative output 8 Positive Output
9 Voltage adjustment 10 Electronic inductance 11 2T/4T change 12 Welding mode selection
13 Voltage display 14 Fault light 15 Power light 16 VRD light
17 Gas input 18 Power switch
19 Input lead bush 20 Rating plate
21 Burn-back knob 22 Wire inching button
Note :
* The ‘protection indicator light’ will come on if the duty cycle is exceeded. It shows that the inner
temperature is over the permitted level, the machine should be stopped being used to allow it cool
down. Welding can
continue after the ‘protection indicator light’ is off.
* The power source should be switched off when not in use.
* Welders should wear protective clothing and welding helmet to prevent injury from arc and thermal
radiation.
* Care should be taken so as not to expose others to the welding arc. Use of screening is
recommended.
* Do not weld near Inflammable or explosive materials.