arcweld 210C MIG, Руководство оператора, Страница: 18 / 31

D-7
TECHNICAL SPECIFICATION
D-7
Connection between Power Source and Input Power Supply
Connect the input cable, (located in the rear panel of the welder), into the single phase 240 voltage
power receptacle of appropriate current capacity and with an appropriately sized circuit breaker.
Input connection sketch
Power supply configure of a welder:
Item
arcweld
®
250C MIG
arcweld
®
250C MIG
Circuit breaker
（
A
）
(‘D’ Curve)
16Amp
* 16Amp (15Amp I/P plug)
32Amp (Max O/P0)
Power cord
（
mm
2 ）
≥2.5mm
2
≥2.5mm
2
* Refer page D-2 for output ratings and input plug rating
The installation and connection for MIG welding
* Select a suitable filler wire according to process being used (Lincoln Ultramag S6 for MIG and
Innershield NR211MP for gasless flux cored welding). The wire diameter must be matched to the
drive roll, the liner and contact tip.
* Open the side panel of wire feeder and mount the wire spool on the spool post. The end of the wire
must be at the bottom of the wire spool, opposite wire feeder inlet guide tube.
* The spool post is fitted with a brake; the wing nut in the centre of the spool post adjusts the brake
tension. Pull the wire from the reel by hand and adjust the tension to provide some drag -