- 10 -
ARCTIV iPDU User Manual M-0010--Rev 2
Address code settings
Turn to the Baud rate and Address code page by press the UP or DOWN button,
then press and hold the CONTROL button for 4 seconds. When an “S” is
displayed in the upper right corner of the LCD screen, press the DOWN button
to select the digit of the Modbus address and press UP button to set digit value
from 0 to 9. Press CONTROL button to save the settings and PDU will restart.
3.
4
Daisy Chain
Ethernet Daisy Chain
Supports daisy chain up to 4 PDUs (1 master and 3 slaves) so the user can
manage multiple PDUs from one IP address through the web interface. Daisy
chain schematic is as follows:
Ethernet Daisy Chain settings
1)
Log in each PDU, and configure the Work mode (Master unit or Slave
unit) on Device Manage page.
2)
Connect the NET port from the Master Unit to the WAN/LAN. Daisy
chain the other PDU’s by connecting the OUT port to the IN port of the
next PDU. Connect all 3 Slave unit by the same method (see Figure
above).
3)
Access the Master unit through the Web interface and check the status
of all the Slave units. If all are readable, daisy chain is successful
WAN/LAN.
Note: Only the same product series can support the Daisy chain connection.
Single phase and Three phase series cannot Daisy chain together
.