Arctiko SUF 100, Руководство по эксплуатации, Страница: 7 / 20

HOW TO RESET THE MAX AND MIN TEMPERATURE RECORDED
1. Hold press the SET key for more than 3s, while the max. or min temperature is displayed. (rSt message
will be displayed)
2. To confirm the operation the “rSt” message starts blinking and the normal temperature will be displayed.
MAIN FUNCTIONS
HOW TO SEE THE SETPOINT
1. Push and immediately release the
SET
key: the display will show the Set point value;
2. Push and immediately release the
SET
key or wait for 5 seconds to display the probe value again.
1. Push the SET key for more than 2 seconds to change the Set point value;
2. The value of the set point will be displayed and the
“°C” or “°F”
LED starts blinking;
3. To change the Set value push the or arrows within 10s.
4. To memorise the new set point value push the SET key again or wait 10s.
HOW TO START A MANUAL DEFROST
Push the
DEF
key for more than 2 seconds and a manual defrost will start.
HOW TO CHANGE A PARAMETER VALUE
To change the parameter’s value operate as follows:
1. Enter the Programming mode by pressing the
Set and DOWN ke
y for 3s
(the
“°C” or “°F”
LED starts blinking).
2. Select the required parameter.
3. Press the
“SET”
key to display its value.
4. Use
“UP”
or
“DOWN”
to change its value.
5. Press
“SET”
to store the new value and move to the following parameter.
To exit:
Press
SET + UP
or
wait 15s without pressing a key.
NOTE:
the set value is stored even when the procedure is exited by waiting the time-out to expire.
THE HIDDEN MENU
The hidden menu Includes all the parameters of the instrument.
6.6.1 HOW TO ENTER THE HIDDEN MENU
1. Enter the Programming mode by pressing the Set+ key for 3s
(the
“°C” or “°F”
LED starts blinking).
2. Released the keys, then push again the Set+ keys for more than 7s.
The Pr2 label will be displayed immediately followed from the HY parameter.
NOW YOU ARE IN THE HIDDEN MENU.
HOW TO CHANGE THE SETPOINT
7