3.1 REMOVAL OF THE PACKAGE
Before proceeding to unpack the appliance check the packing of the cooler and its
protections.
Any damage should be reported immediately to the carrier.
Under mo circumstances any damaged appliance can be returned to the manufacturer
without prior written authorisation.
Romove all the polythene material, and pay attention not to scratch the sides with
sharp blades or scissors.
Use a fork-lift to lift the appliance and take it to the place of installation, make
sure that the load is balanced.
The components of packing should be disposed according to the local law.
Some components of the packing are marked as recyclable.
ATTENTION: During transportation, do not heavily pull or push the product, and try
to keep the inclination angel between the cabinet body and ground to be no more
than 45
°
.
3.2 POSITIONING
The appliance must be placed in an adequately ventilated room as far as possible
from any heat elements, such as radiators or hot pipes.
Make sure that the distance between the wall and the back of the cooler is not less
than 10 cms and that the front ventilation grill is clear, to allow free air
circulation to the refrigerator unit, which is located at the base of the appliance.
3.3 ELECTRICAL CONNECTION
The cooler works on single phase voltage power supply.
To switch on the appliance, just insert the plug into the main socket, make sure
that:
-the main socket is provided with efficient ground, the voltage and frequency of
the electric line matches with those indicated on the nameplate. In case of doubts
about the efficiency of the ground, have your electric line checked by a qualified
technician.
-a circuit breaker featuring at least 3mm distance between the opening contacts has
been linked up between the socket and the power supply.
The manufacturer declines any responsibility for possible damages or accidents
arising from the violation of the rules above exposed or of the safety electric laws
relevant the country of use of the appliance.
4. USE
4.1 POWER ON AND ADJUSTMENT OF THE TEMPERATURE
The cooler is not provided with a main switch; therefore, the electric components
are supplied at the moment that you insert the plug into to the main socket. To switch
off the cooler, turn off the circuit breaker or just disconnect the plug from the
socket.
(Refer to Pic.2).
The internal cell temperature can be adjusted by rotating the thermostat knob
“
B
”
.In
the
“
MAX
”
the position the temperature will reach the lowest by the appliance.
Refer to the technical data chart to know the temperature range.
