the formation of mould and bad smells.
·
Make sure that the premises is aired regularly.
6. EXTRAORDINARY MAINTENANCE OPERATION
6.1 TROUBLE SHOOTING
Generally, the faults that occur during performance are caused by banal mistakes
nearly all resolvable without the assistance of a specialized technician, therefore
before getting in touch with a technical assistance centre, verify the following
points:
A-
The appliance does not start.
-check that the plug is correctly inserted in to the socket.
-verify that there is power supply at the socket.
B- The internal temperature is too high.
-check the adjustment of the thermostat.
-check the perfect closing of the door.
C-The appliance is excessively noisy.
-verify the level of the appliance. A not levelled appliance could cause some the
vibrations.
-check that the cooler is not touching other coolers or other parts that could enter
in resonance.
Carry out this Check-up and if the fault persists, get in touch with our technical
assistance centres.
Remember to remark:
-the type of fault (electrical, mechanical)
-the code and serial number of cooler that can be found written on the sticker
attached in the cell and on the back site of the appliance.
The extraordinary maintenance operations must be carried out by specialized
personnel only. These personnel can require a service manual from the manufacturer.
7. DISPOSAL AND DEMOLITION
7.1 WASTE STORAGE
Temporary storage of special waste is permitted but only if the final purpose will
be the definitive disposal by treatment and/or final collection.
Dispose the special waste according to the law regulations of your country.
Keep the environment clean.
7.2 PROCEDURES FOR THE DISASSEMBLY OF THE APPLIANCE.
The specific prescriptions requested by the legislation and local authorities for
each country where the cooler will be demolished must be observed.
A general rule is to hand over the cooler to specialized collection/demolition
centres.
Disassemble the cooler and divide the components separately according to their
chemical characteristics. Remember that the compressor contains oil and refrigerant
gas which can be recycled.
The coolers components are categorised as special urban waste.
THE DISASSEMBLY OPERATIONS MUST BE CARRIED OUT BY QUALIFIED PERSONNEL.
8.ENCLOSED DOCUMENTS
