26
2. Be sure to maintain the brake fluid at the
proper level and take care not to get any
moisture in the system as moisture in
the brake fluid lowers the boiling point.
If the brake fluid is ever boiled (by high
speed stops or repetitive use) or if mois-
ture is allowed to enter the system, it
must be changed. Never substitute or
mix different types or grades of brake
fluid.
3. Never ride the brake. Even main-
taining minimal pressure on the
brake lever will cause the brake pads
to drag on the disc and may overheat
the brake fluid.
4. The brake lever lock is not a parking
brake and should not be applied for
periods exceeding 5 minutes.
NEVER OPERATE THE SNOW-
MOBILE WITH THE BRAKE
LEVER LOCK ENGAGED.
5. Pumping the brake lever is permissible;
however, if pumping the brake lever
more than twice is necessary to obtain
the necessary stopping power, immedi-
ately take the snowmobile to an autho-
rized Arctic Cat Snowmobile dealer for
service. If not under warranty, this ser-
vice is at the discretion and expense of
the snowmobile owner.
6. When new brake pads are installed,
a “burnishing” process is required
(see Brake System in the Mainte-
nance section of this manual).
Emergency Stopping
There are several methods of stopping or
slowing the snowmobile under a variety
of situations. Identified in the following
chart are the ways a snowmobile may be
brought to a stop and the effectiveness
under normal conditions.
Throttle/Ignition
Monitor Switch
The throttle control is equipped with a
monitor switch for safety purposes which
will stop the engine when a loss of return
spring force occurs. If ice forms in the
throttle system or if there is some other
malfunction of the throttle system result-
ing in a loss of return spring force, the
monitor switch will stop the engine when
the throttle control lever is released.
If the snowmobile engine stops abruptly
when the throttle control lever is released
and the activation of the monitor switch is
suspected, use the following procedure:
1. Rotate the ignition key to the OFF
position.
2. Remove ice and snow from the
throttle system and wait 5-10 min-
utes for the engine heat to thaw ice
from the throttle system.
! WARNING
Use only Arctic Cat approved DOT 4
brake fluid. Never substitute or mix
different types or grades of brake
fluid. Brake loss can result. Check
brake fluid level and pad wear before
each use. Brake loss can result in
severe injury or even death.
! WARNING
The brake lever lock is not a parking
brake and should not be applied for
periods exceeding 5 minutes. The
brake lever lock maintains the brake
lever in the compressed position and
maintains pressure against the brake
disc; however, after a period of time,
the pressure applied to the brake disc
may relax below the amount required
to hold the snowmobile stationary.
Item
Function
Condition
Emergency
Stop Switch
interrupts igni-
tion circuit
ALL
Throttle/Ignition
Monitor Switch
interrupts igni-
tion circuit
ALL
Ignition Switch
interrupts igni-
tion circuit
ALL
Brake
slows the drive
system
ALL
Tether (HCR
and RR models)
interrupts igni-
tion circuit
ALL
! WARNING
If any malfunction of the throttle sys-
tem occurs (such as freezing in fluffy
snow) and the monitor switch does
not shut off the engine, press down
on the emergency stop switch IMME-
DIATELY to stop the engine. DO NOT
start the engine until the malfunction
in the throttle system has been
located and corrected.
Содержание F 1100 series
Страница 7: ...3 Snowmobile Safety Rules...
