88
INSTALLING
1. Install new O-rings in the grooves of the gear case;
then grease the center splines of the axle and install
in the gear case from the left side.
KM527
2. Install the rear axle and gear case into the right side
of the swing arm; then secure the gear case to the
swing arm assembly with the eight cap screws.
Tighten to 50 ft-lb.
KM528A
3. Apply grease to the universal joint splines and drive-
shaft splines; then install the driveshaft spring into
the driveshaft.
KM529
NOTE: Apply a liberal amount of grease to the
driveshaft splines and the driveshaft spring. This will
aid in keeping the spring in position while assembling.
4. Insert the driveshaft assembly into the swing arm
tube; then engage the driveshaft splines with the pin-
ion shaft splines in the rear drive gear case.
KM530
5. Pack approximately 3 g (0.1 oz) of grease into each
swing arm pivot bearing cavity; then apply grease to
the lips of the dust seals.
KM531
6. Align the swing arm assembly in the frame and
engage the universal joint onto the splines of the sec-
ondary driven bevel gear shaft.
KM532
7. Install the right pivot bolt and left pivot adjusting
bolt and tighten securely; then move the swing arm
up and down to seat the bearings. Tighten the left
pivot bolt to 36 in.-lb and the right pivot bolt to 82
ft-lb.
8. Install the left pivot lock nut; then while holding the
left pivot adjusting bolt, use Pivot Lock Nut Wrench
to tighten the lock nut to 82 ft-lb.
Содержание Altera 300
Страница 1: ...2017 S SERVICE ERVICE MANUAL ANUAL www arcticcat com ...
Страница 99: ...98 NOTES ...
Страница 100: ...99 NOTES ...
Страница 101: ...100 NOTES ...