20
XA072
Rear Rack/Body
Panel/Fender
REMOVING
1. Remove the seat, steering post cover, gas tank cover,
battery, and both left and right footwells.
NOTE: When disconnecting the battery, disconnect
the negative cable first, then the positive cable.
2. Disconnect the green ground wire (A) and starter
relay primary connector (B). Remove the SIG relay
(C) and starter relay from the rear body panel. Using
a flat blade screwdriver, lightly pry against the PDM
locking tab (D) to release the PDM from the rear
body panel.
XA076A
XA078A
3. Remove the six cap screws securing the front body
panel to the frame and gas tank. Pull the front body
panel out and away from the frame.
XA077A
4. Remove the self-tapping screws securing the rear
over-mold to the rear rack; then remove the four cap
screws securing the rear rack to the frame. Remove
the rack. Account for the four steel inserts installed
into each rubber grommet.
XA080A
XA081A
5. Located under the left rear fender, loosen the clamp
securing the two halves of the CVT outlet pipe. Dis-
connect the two halves.
XA079A
Содержание Altera 300
Страница 1: ...2017 S SERVICE ERVICE MANUAL ANUAL www arcticcat com ...
Страница 99: ...98 NOTES ...
Страница 100: ...99 NOTES ...
Страница 101: ...100 NOTES ...