Arctic Cat 500 4x4, Руководство оператора

Страница: 41 / 76

���������� ����������� �������� �����������������
������ ��� ��
��������������� ��
������� ��� � ��� ����������
���������� ������������
Page 39
!! WARNING !!
Anytime service is performed on
a battery, the following must be
observed: Keep sparks, open fla-
me, cigarettes or any other flame
away. Always wear safety glasses.
Protect skin and clothing when
handling batteries. When servicing
battery in enclosed space, keep the
area well-ventilated.
To charge the battery, use the follo-
wing procedure:
1. Remove the battery hold-down
bracket.
2. Remove the negative battery
cable; then remove the positive
cable and the battery vent tube.
Remove the battery.
!! WARNING !!
Avoid contact with skin and eyes.
!! CAUTION !!
Do not charge the battery while it
is in the ATV with the battery termi-
nals connected.
3. Remove the vent plugs; then (if
necessary) fill the battery with dis-
tilled water to the MAX level indica-
ted on the battery.
4. Charge the battery at 1,4 amps
for 10 hours.
!! CAUTION !!
Never exceed the standard char-
ging rate.
5. After charging, check fluid level
and fill with distilled water as ne-
cessary; then install vent plugs.
!! CAUTION !!
Before installing the battery, make
sure the ignition switch is in the
OFF position.
6. Place the battery into position in
the ATV and secure with the hold-
down bracket.
7. Attach the vent tube and check
the vent tube to make sure it is not
crimped and that it is properly secu-
red to the frame.
8. Clean the battery posts and ca-
ble ends.
9. Connect cables to the proper
terminals. Connect the negative
cable last.
!! CAUTION !!
Be sure to connect the positive
cable to the positive terminal and
the negative cable to the negative
terminal!