3-145
3
GZ342
5. Tighten the 6 mm cap screws to 8 ft-lb and the 8
mm cap screws to 20 ft-lb using the pattern shown
and turning the shafts frequently to ensure there is
no binding.
NOTE: Rotate the shafts back and forth to ensure
no binding or sticking occurs.
GZ457A
NOTE: Cap screw number eight (8) is installed
from the right side.
NOTE: If the secondary drive/driven assemblies
have been disassembled, refer to Servicing Center
Crankcase Components for proper gear tooth con-
tact and backlash.
6. Install the locating ring in the crankcase assembly;
then install the secondary driven shaft assembly
and secondary drive assembly making sure the
locating ring and bearing engage correctly.
GZ269A
GZ448A
7. Make sure the locating pins on the front and rear
bearings are correctly seated in the crankcase.
8. Install two locating pins into the upper crankcase
assembly; then apply a thin bead of silicone seal-
ant to the lower crankcase cover.
GZ452A
GZ451
9. Carefully place the lower crankcase cover onto the
joined crankcase halves; then secure with the cap
screws. Tighten the 6 mm cap screws to 8 ft-lb and
the 8 mm cap screws to 20 ft-lb.
Next
Back
Section
Table of Contents
Manual
Table of Contents
