3-98
GZ200
5. Using an awl, rotate the C-ring in its groove until
it is out of the cylinder head; then remove the
C-ring.
NOTE: Care should be taken not to drop the
C-ring into the crankcase.
GZ155
6. Bend the washer tabs down and remove the two
cap screws securing the sprocket to the camshaft;
then drop the sprocket off the camshaft.
GZ154A
7. While holding the chain, slide the sprocket and
camshaft out of the cylinder head.
CC266D
NOTE: Loop the chain over the cylinder head and
secure it to keep it from falling into the crankcase.
8. Remove the five nuts securing the cylinder head to
the cylinder; then remove the four cylinder head
cap screws and washers.
NOTE: Removing the starter will simplify removal
of the front cylinder base nuts.
GZ136A
GZ132B
9. Remove the cylinder head from the cylinder,
remove the gasket, and account for two alignment
pins; then remove the cam chain guide.
Next
Back
Section
Table of Contents
Manual
Table of Contents
