Arconic DT4600, Инструкция по эксплуатации

Страница: 6 / 14

6
DT4600 Pneudraulic Installation Tool (HK1174)
Use the table on the right to determine the
nose assembly and fastener combinations
recommended for your tool.
Nose Assembly/Fastener Compatibility
Attaching and Removing a Nose Assembly
CAUTIONS:
Attach only those nose assemblies which
are specifically recommended for use with
this tool.
Install only those fasteners specifically
recommended for use with this tool.
The use of nose assemblies and/or
fasteners not recommended for this tool
can result in equipment damage.
Fastener
Size
Fastener Type
Nose Assembly
Number
-06
MGL Standard,
self-releasing
99-3303
-08 MGL self-releasing 99-3305
-06 MG 99-1456
-08 MG 99-1458
-06 C6L 99-3003
-08 C6L 99-3006
-06 BB 99-2707
-08 BB 99-2713
-06 BR 99-2737
-08 BR 99-2743
-04, -05, -06 Huck-Clinch®, HuckMAX®,
NAS1919/1921U
99-3459-202
-05, -06, -08 BB (Rivet Pintail) 99-3482
Anvil
Insert
Anvil
Holder
Collet
Chuck
Jaws
Follower
Spring
Cap
Nose Spindle
Extension
NON-L SERIES
Anvil
Assembly
Collet
Unitized
Jaws
Spindle
Extension
NON-L SERIES
with UNITIZED JAWS
INSTALLING A NOSE ASSEMBLY
1. Using a 1 inch wrench, remove
Retaining Nut and Anvil
Adapter.
2. Screw Collet onto Spindle
Extension and, using an 9/16
inch wrench to hold Spindle
Extension in place, tighten
Collet using an adjustable
wrench.
3. Slide Anvil Adapter over Collet
and tighten.
4. Slide Anvil into Anvil Holder,
and tighten Retaining Nut
using a 1 inch wrench.
Figure 2