Arconic 2580, Инструкция по эксплуатации

Страница: 13 / 28

13
2580 series Hydraulic Installation Tools (HK961)
15. Screw the coupling nipple onto the PULL
pressure hose (from port P of tool). Screw the
coupling body onto the RETURN pressure hose
(from port R of tool).
16. Hold a 3/8” hex wrench in the back of the tool
when tightening the collet. Use the pintail tube
if necessary.
NOTE : See p
reparatIon
f
or
u
se
before attaching
the nose assembly and operating the tool.
Assembly (continued)
WARNING: Connect the tool’s
hydraulic hoses to the Powerig
®
before
connecting the (air or electric) trigger
assembly to it. If not connected in this
order, serious personal injury could
occur.
CAUTION: Anvils with ears must have
a stop installed in position as shown to
prevent damage to the ears; slide the
stop over the anvil before installing the
retaining nut.
Figure 4
Installing the
Piston
Subassembly Part Numbers and Notes
Refer to the Assembly Drawings in this manual.
NOTE : Numbers in parentheses are Huck part numbers.
1 An optional 12 ft. Hose Kit ( 122854 ) is available. See Figure 11 .
2 Front Grand Assembly ( 123139 ) includes: Back-up Ring ( 501118 ), O-ring ( 500824 ), Wiper ( 505894 ), Front
Wiper Housing ( 123138 ), Polyseal ( 506160 ), and Front Gland ( 123137 ). See Figure 5 .
3 Piston Assembly ( 123136 ) includes: Piston ( 123135 ) and GLYD Ring ( 506180 ). See Figure 5 .
4 Rear Gland Assembly ( 123142 ) includes: Back-up Ring ( 501118 ), O-ring ( 500824 ), Wiper ( 505991 ), Retaining
Ring ( 506182 ), Spacer ( 123141 ), Polyseal ( 506181 ), and Rear Gland ( 123140 ). See Figure 5 .
5 Trigger Cord Assembly ( 123338 ) includes: Strain Relief ( 505344 ), Male Connector ( 110686 ), Trigger Switch
Assembly ( 120361 ), and Control Cord ( 123337 ). See Figure 6 .
6 CAUTION : Install the cups of Polyseals and wipers as shown. See Figure 5 .
7 Torque socket-head screw ( 506030 ) to 20 (+/-3) in.-lbs. See Figure 5 .
8 Blind fasteners require Pintail Tube ( 108279 ). See Figure 5 .