ArchWork ARCLINEA36TRI, Руководство пользователя

Страница: 28 / 32

ARCLINEA36TRI
12
3.11 White calibration
Enter the CALIB mode to select white color of different color temperature;
• Press the button MENU so many times until show [ CAL1 ] and press the button ENTER to confirm.
• There are 11 pre-programmed white colors ( WHITE01 - WHITE11 ) can be edited by using red, green and blue
( Red - Green -Blue ), through the UP and DOWN.
Note. In the ARCFULL configuration is possible to balance custom color temperature settings by selecting
white WHITE01 - WHITE11 CH5.
• Select [ RGB ] to set the values ( 000 - 255 ) on the CH red, green and blue.
- 4 - MAINTENANCE
4.1 Cleaning the unit and maintenance
• Make sure the area on the installation site is free from unwanted persons during setup.
• Housings, fixations and installation spots should be totally free from any deformation.
• The main cables must be in impeccable condition and should be replaced immediately even when a
small problem is detected.
• It is recommended to clean the front at regular intervals, from impurities caused by dust, smoke, or other
particles to ensure that the light is radiated at maximum brightness. For cleaning, disconnect the main
plug from the socket. Use a soft, clean cloth moistened with a mild detergent. Then carefully wipe the
part dry. For cleaning other housing parts use only a soft, clean cloth. Never use a liquid, it might pen-
etrate the unit and cause damage to it.