Architect 1600 SE, Руководство по сознательной установке для профессионалов

Страница: 18 / 36

®
equalizing the System
Equalizing the System
Before proceeding on to setting up the Speaker Optimization
controls on the Architect, it’s a good idea to make sure that you
have everything connected and working properly.
1. Double-check all connections. Make certain that all of the
audio and speaker connections are firmly seated and tightened
down.
2. Turn on your audio system. The Power LED on the Architect
should be Blue, the Protection LED should be Blue (after a
few seconds of Red on startup) and (unless you have defeated
the Signal-Sense) the Channel Status LEDs should be off.
3. Start one of the audio sources playing and send that signal
to the Architect (how you do this depends on your particular
multi-room system). The zone status LED should illuminate
Blue within one second after the music begins.
4. Check each speaker output zone to ensure that each one plays
properly.
5. With all the speaker loads turned on, turn up the volume and
make certain that the channel status LEDs on the Architect stay
Blue. If they slowly toggle between Blue and Red, then there
is either a short in the speaker wiring, or the combined speaker
load is too low.
Congratulations! You’re ready to go on to setting the Speaker
Optimization controls.
The following are examples of typical settings of the
Architect™ Model 1600 SE Series Speaker Optimizer
controls. Naturally, the results of adjustments will vary de-
pending on the individual acoustic environment, the type
of speakers, and the personal preferences of the listener.
These recommendations are not concrete, they are simply
good starting points.
Note: For the absolutely
best results, The speaker
optimizer controls on the
Architect
tm
Model 1600 SE/1601 SE
should be adjusted with a real time
analyzer such as the AudioControl
Industrial SA-3052.
14
Example Settings
SA-3052