Archgard 25-BVI20N-3, Руководство пользователя по установке, эксплуатации и техническому обслуживанию, Страница: 13 / 44

25-BVI20N – 3 13
ATTACHMENT OF FIREPLACE SURROUND
1) The surround has four hooks that clip onto the sides of the appliance. Make sure the
surround sits evenly with the front of the fireplace. After the surround is properly installed, the
bottom edge of the centre section of the surround is about ¾ ” from the top of the appliance.
3 - THE SPILL SWITCH
IS CONNECTED TO THE
APPLIANCE (FACTORY -
WIRED)
2) If needed, two securing brackets are provided to stabilize the appliance in shallow zero -
clearance fireplaces. Screw these to the top of the appliance and to the face of the host fireplace.
Use the holes on the bracket that best suit your application.
INSTALLATION INSTRUCTIONS - Continued
1
2
3) The spill switch is manual reset type that can be reset by pressing the pin between the two
wire terminals with a small probe once the fireplace has cooled to the touch. This part is mount-
ed on the unit and can be seen between the louvers once installed in the center top section. You
will feel a small click once reset and the unit should relight. If the problem persists, call your
dealer for technical assistance. Do not bypass this safety device .
A pilot shield is packaged with this unit in the event that it is required for installation. This is
only required by the technician installing the unit if deemed necessary for cold pilot start up.
Refer to the placement diagram below.
Part # 822 - 0060