11 | EN
gas connection and avoid gas
leakage.
•
Plastic hose to be used must not
be longer than 125 cm.
•
Install the clamp to the hose. Soak
one end of the hose (15 mm inner
diameter) into boiling water for one
minute to soften it.
•
Than, slip the softened end of the
hose completely onto the sharp
hose end of your appliance. Finally,
tighten the clamp completely by a
screwdriver.
•
Repeat the same procedure for the
other end of the hose and
complete the gas bottle
connection.
•
Never forget to make the gas
leakage control.
Risk of explosion and
suffocation!
LPG bottles must not be stored
in the house.
•
If you need to use your appliance
later with a different type of gas,
you must consult the authorized
service for the related conversion
procedure.
1
Hose nozzle for LPG
2
Safety tube
Leakage control at the connection
part
•
Make sure that all knobs on the
appliance are turned off. Make
sure that the gas supply is open.
Prepare soapy foam and apply it
onto the connection edge of the
hose for gas leakage control.
•
Soapy part will froth if there is a
gas leakage. In this case, inspect
the gas connection once again.
Never use a match or lighter to
make the gas leakage control.
Risk of explosion by damage of
the safety tube!
The safety tube must not be
clamped, bent or trapped or
come into contact with hot parts
of the appliance.
Connection to the mains supply
This appliance must be
earthed!
Our company shall not be held
responsible for any damage
caused by using the appliance
without earthed socket.
Risk of electric shock, short
circuit or fire by unprofessional
installation!
The appliance may be connected
to the mains supply only by an
authorized qualified person and
the appliance is only guaranteed
after correct installation.