5
TO REMOVE/REPLACE BREATH DEFLECTOR
To remove, grasp either side of the edge and pull
upward and toward to opposite end.
To install, first insert the center of the deflector
in the receiving slot and then push in the sides
working from the center outwards.
NOTE:
If you do not use the deflector we recommend you to install Anti-mist
spacer (optional) in this place as it actually acts as an anti mist ducting device.
1
22
1
WARNING:
DO NOT pull Chin Cover. Read instructions completely before
attempting removal. Failure to do so may result in damage to the cover
and/or helmet.
To replace, begin with the helmet upside down on a table or in your lap.
Pull Airflow Spoiler down to its fully open position.
To remove, begin with the helmet upside down on a table or in your lap.
Center Chin Cover over the spoiler and position the two mount clips between
the spoiler and shell. With both thumbs press both clips down until you feel
and hear a positive “click”
TO REMOVE/REPLACE CHIN COVER
Lay plate of the Chin Cover on the bottom
edge as shown. Repeat for the other side.
Press the remaining right and left clips down
until you feel and hear a positive “click”.
Grasp the Chin Cover as shown and slide/rotate
the entire cover to the left by approximately
2cm (3/4)
①
. Lift the cover out
②
.
