SERVICE INFORMATION
CONCERNING THE 6000 SERIES GAME
To update the
series game to use the shorter 5
T-10 40 watt lamps instead of the 11
T-8 40 watt
lamps, you will need to do the following:
WARNING: UNPLUG THE GAME FROM THE WALL OUTLET BEFORE SERVICING!!!
1. Move the (2) lamp sockets located on
sides down to the lower end of the shadow box. The crimp-on
will have to be removed by cutting as close as possible to the connector located inside the back of
the
Wire nuts will be used to refasten these wires. The socket will bc pointing up instead of down. The
for
socket should be located about one inch up from the lower
A
hole will have to be
drilled into the back panel for the wires. This can be done from the back of the game (plan ahead to get the
in the right spot). The Arachnid part number on this lamp is 11-0007.
2 .
Aluminum reflective foil with adhesive back (commonly available from an automotive supply store) MUST
be installed between the lamp and the wood shadow box for two reasons:
A: HEAT The tape spreads the heat and protects the wood.
LIGHT It reflects the light giving twice the illumination on the target as compared to the
long bulbs without the foil.
foil that
WC
arc using is 2
9” and is bent into an
(the long direction) before inserting in the
shadow box.
part number from Arachnid for the foil is
Although the short bulbs can be installed without moving the sockets down, the aluminum tape MUST bc
used
to the increased heat of the shorter bulb. Moving the sockets down helps to distribute the light more
evenly.
If there are any questions concerning this update, please call l-800-435-8319 (in Illinois l-815-654-0212).
I
The Originator of Electronic Darts
