The Dart Head must be rotated 90 degrees. This will make the 11 become the 20. (See Figure
The 20 has red single segments, so to conform with the standard segment colors, take the Dart
Head apart and rotate the segments one position. Do not rotate the switch matrix.
(Figure 15) Reassemble Dart Head and mount in game with the pigtails facing down. Using piece
cut out of upper cabinet in figure 2 and supplied
brackets mount support behind plastic front
panel, Plug pigtails into the Target Interface Board, install standoffs, and position board in the
area shown. Be careful to find a position that puts minimum strain on the pigtails. Peel backing
off the standoffs and attach below the Dart Head. (Figure 15) Optional speaker location may be
used on 5000’s without modification, on the 4500’s drill ten
dia. holes within a 3” dia. circle to
allow sound to come forward.
(Figure
The notch in the back door must be on the left side, looking from the rear of the game.
To accomplish this, the back door must be reversed. Cut the
brace off flush with the bottom.
Add the new brace to the opposite side. The lock and speaker must also
to the other side
of the door. The newer 4500 series will not have the speaker on the door; leave it where it is. At-
tach FCC label where shown in Figure 16. Connect the lamps, Target Interface Board, and
speaker to main harness and P.C. Board; close the cabinet back.
STEP
MODIFYING THE COIN DOOR
See the instructions on Coin Door Update.
ROTATE ALL SEGMENTS
ONE POSITION
SEGMENTS
FIGURE 14
OPTIONAL SPEAKER
*
LOCATION
I
I
-
DART HEAD
FLAT
(2) L BRACKETS
TARGET INTER
FACE BO
AR
D
FIGURE 15
RELOCATE LOCK,
SPEAKER, AND
SPEARER
If there are any questions regarding these
NEW BRACE ON
OPPOSITE SIDE
THE
HAVE TO
BE ADDED TO SOME
IF YOU HAVE TO CUT A
SLOT, REVERSING THE DO
IS NOT NECESSARY.
ATTACH FCC
LABEL HERE
FIGURE 16
please call Arachnid, Inc. at l-800-435-8319
(in Illinois
37-0130 Rev. c
P 0 Box 2901 Rockford. IL
( I L )
. 8 0 0 1 4 3 5 8 3 1 9
