120
- Holding the Menu key for more than 5 seconds
will recover the source data.
121 -The schedules of calendars 1 and 2, as well as
the hours of operation and lit, will be maintained.
In case there is no graphic representation on the display, we can perform the data recovery, following
the instructions below
Disconnect the stove. Keep the increment key pressed and then connect the stove again without releasing the
increment key.
After a few seconds, a numerical representation corresponding to the data that is being recovered will
appear. Release the increase key.
Adjustment of combustion air.
As we have already indicated on page number 5, the adjustment of the combustion air must be done as
carefully as possible.
Once the stove is on and has reached the
power level 5
, we enter the combustion air setting "
Menu 1- 6a
".
The flame must have liveliness without getting rid of fuel from the basket, that is, the flame must be vertical
but there must be too much air at the combustion point (basket).
We will observe that the tips of the flame tend to have an orange color without these traces of smoke. The
increase or decrease of the air level in the “
Menu 1-6a
”, it will be done varying
+/- .01mB
and waiting for next
30 seconds approximately
, so that the modified value stabilizes. Depending on the results, we will continue
the adjustment or conclude the same. It is very important that the duration of this regulation be at least
15
minutes.
Observe when the stove is off and the cooling process is complete, if the bottom of the hearth has a grayish
color and no traces of dark areas, if so, combustion is proving satisfactory.
This regulation will remain
permanently
in the stove, so it is not necessary to modify it again.
The Viriato cpu will self-regulate combustion air based on the fuel, power required and waste
accumulated during the operation of the stove.
If the minimum air required by our combustion is not reached, the stove will turn off indicating
insufficient air in the combustion.
16
