AR 10013130, Руководство по эксплуатации и обслуживанию

Страница: 34 / 68

Model 2000TP2G8B
24 Rev -
Table 3-4. Catalog of Status Codes
(The RDSTAT command causes the TWTA to return a string in the form STATUS=[ code ], where [ code ] is
an ASCII number whose meaning is given below)
Status Code Meaning
0 No command was given
1 Last command was successful
2 Last command is in process.
3 Last command failed to complete. Time-out.
10 Last command failed. Invalid command.
11 Last command failed. Data was unparseable.
20 Last set command failed. Data was beyond high limit.
21 Last set command failed. Data was beyond low limit.
22 Last set command failed. Data was out of range
23 Last set command failed. Data was wrong polarity
50 Last command failed. Local system does not have remote enabled.
51 Remote system is not ready to accept commands.
901 Assert error: invalid table argument*.
902 Assert error: invalid calibration*.
* Please call a service representative if you observe this error.
Table 3-5. Catalog of Fault Codes
(The RDFLT command causes the TWTA to return a string in the form flt=[ code ], where [ code ] is an ASCII
number whose meaning is given below)
Fault Code Meaning
0 No fault
7 SYSTEM FAULT
8 FIL NOT READY
9 LOW LINE
10 CATH O/VOLTAGE
11 BODY O/CURRENT
12 CATH U/VOLTAGE
13 O/PLS WIDTH (turns RF off only)
14 OVER DUTY(turns RF off only)
15 COLL U/VOLTAGE
16 INVERTER FAULT
17 INTERLK OPEN
18 TUBE ARC
19 TWT OVER TEMP(h)
20 CABINET O/TEMP(h)
22 EXTERNAL INHIBIT(turns RF off only)
23 OVER REV POWER
26 Panel Open
30 GRID O/VOLTAGE