AR 1000S1G6C, Руководство по эксплуатации и обслуживанию

Страница: 50 / 86

Model 1000S1G6C
26 Rev A
2.8 CONTROL LINES
This section defines all required control lines to be utilized by the control software and any actions (faults or
alerts) that the control software must perform.
In the tables below, indicate the NO ACTION STATES (or the correct operating states) of each line required
and any actions that are required if the line is out of bounds.
•
If the Fault? column is checked, add detailed fault information in section 2.9
•
If the Fault? column is NOT checked but an action is performed, add detailed action information in section
2.9.1
2.8.1 Switch Breakout Board (A34A2)
2.8.1.1 Connector J9
Notes
Indicate a range representing a NO ACTION STATE (i.e. +1.2 Vdc << +2.3 Vdc)
Once activated, inputs are checked for all following control states
Guaranteed operation between 0.0 Vdc and +3.3Vdc (damage occurs outside this range)
Control
Line
Input Control States
Defined in section 4
Fault?

= Yes
General Description
Add fault description in section 2.9
Add non-fault description in section 2.9.1
Pwr OFF
RF OFF
Pwr ON
RF OFF
Pwr ON
RF ON
J9 – 1 Analog
J9 – 2
Analog
J9 – 3 Analog
J9 – 4
Analog
2.8.1.2 Connector J8
Notes These outputs are not state-driven (always on) and can be set to a fixed value in the range of 0.0 Vdc to 4.8 Vdc
Line Output Value
J8 – 1 Analog
J8 – 2 Ground
J8 – 3 Analog
J8 – 4 Ground