AR 10006896, Руководство по эксплуатации и обслуживанию

Страница: 35 / 68

Model 500T2G8
Rev E
23
Table 3-4. Catalog of Status Codes
(The RDSTAT command causes the TWTA to return a string in the form STATUS=[code], where [code] is
an ASCII number whose meaning is given below)
Status Code Meaning
0 No command was given or last command was successful.
2 Last command is in process.
3 Last command failed to complete. Time-out.
10 Last command failed. Invalid command.
11 Last command failed. Data was unparseable.
20 Last set command failed. Data was beyond high limit.
21 Last set command failed. Data was beyond low limit.
22 Last set command failed. Data was out of range
23 Last set command failed. Data was wrong polarity
50 Last command failed. Local system does not have remote enabled.
51 Remote system is not ready to accept commands.
901 Assert error: invalid table argument*
902 Assert error: invalid calibration*
* Please call a service representative if you observe this error.
Table 3-5. Catalog of Fault Codes Returned by RDFLT Command
(The RDFLT command causes the TWTA to return a string in the form flt=[code], where [code] is an ACSII
number whose meaning is given below).
Fault Code Meaning
0 No fault
7 System Fault
8 Heater Fault (Fil not Ready)
9 Low Line
10 Cathode overvoltage
11 Body overcurrent
12 Cathode undervoltage
15 Collector undervoltage
16 Inverter fault
17 Internal interlock open
18 Tube arc
19 TWT (hardware) overtemperature
20 Power supply (hardware) overtemperature
22 External inhibit
23 Over reflected power
26 Panel Open
27 Latched Fault
30 Grid Overvoltage
49 TWT (software) overtemperature
50 Cabinet (software) overtemperature