Aquion ProSystems NRV 1044, Руководство пользователя

Страница: 5 / 12

within normal operating temperatures, but will melt in a torch flame.
• To prevent hot water from backing up into the conditioner, avoid short connections of pipe between
the conditioner and the hot water heater. If you can’t avoid a short connection, move the equipment
to another location. As a last resort, install a check valve. If the check valve causes “water hammer”,
install a water hammer suppressor
.
• Connect the raw water pipe to the INLET pipe connection of the bypass valve. When looking from the
front of the unit, the inlet is the pipe connection on the RIGHT side of the valve.
• Connect the treated water pipe to the OUTLET pipe connection of the bypass valve. When looking
from the front of the unit, the outlet is the pipe connection on the LEFT side of the valve.
8. TURN ON THE WATER AND TEST FOR LEAKS AND FLUSH THE PLUMBING
• Before turning the water back on, place the system in the bypass position, then close all of the faucets
except one cold water tap from a bath tub.
• Turn the water on slowly and allow the water to flow out the bath tub for several minutes to remove
any dirt, solder, glue, etc. from the plumbing system.
• Once the water runs clear, turn the bypass valve handles to the service position and allow the water
to fill the system. It is common for water to show some color ( grey or brown) for a few minutes. Allow
the water to run for 20 minutes or until 100 gallons have passed through the system. Once the water
runs clear shut off the bath tub.
• The system will now pressurize, allowing you to check for any leaks.
• To flush any remaining untreated water from the hot water heater, run hot water in the bathtub until
cold; close the faucet.
The installation is complete and the system is ready for use.
5