Aquion ProFlow, Техническое руководство

Страница: 14 / 52

ELECTRONIC CONTROL PANEL
Page 14
DUPLEX ECO ALTERNATING :

The 2 Simplex systems, that make up a Duplex system,
must be programmed individually; the program does NOT
necessarily have to be the same on the 2 Simplex systems!
1. Press the scroll button and hold it for 5 sec until the
display shows:
2.
Within 10 sec, press the up button; the display will
show:

Press the up or down button to set the hardness
unit . Make sure to also adjust/convert the exchange
capacity!
3.
Press the scroll button again; the display will show:

Press the up or down button to set the
exchange capacity per litre of resin .
4.
Press the scroll button again; the display will show:

Press the up or down button to set the volume
of resin .
5.
Press the scroll button again; the display will show:

Press the up or down button to set the length
of the regeneration cycle .

Press the scroll button again to advance to the next
regeneration cycle.
Cycle 1 Backwash
Cycle 2 Brine draw/slow rinse
Cycle 3 Fast rinse/refill
6.
Press the scroll button again; the display will show:

Press the up or down button to set the type of
water meter sensor .
7. Press the scroll button again; the display will show:
 Press the up or down button to save the
program into the NOVRAM® and exit the
programming level.
8.
Repeat steps 1-7 for both Simplex systems.
Cycle 1: XX min
System Check
HardUnit: °f
Resin: XXX liters
ExCap: 5.5 °f M3/L
MTR: SNAP SENSOR
Exit