8
AQ-OP-00010_E
5. Installation Procedures
5.1 Unpacking
Unpack Modules carefully and document any damage.
Battery Modules are permanently fastened to pallets. Fork trucks and pallet jacks can be used to
move and position Battery Modules.
5.2 Installation
AHI Battery Stacks are compressed and designed never to be dismantled.
WARNING: Do NOT attempt to disassemble Battery Stacks. Do NOT remove the nut on the
compression fixture on top of the Stacks in the Module. Battery Stacks have been compressed to
optimize battery performance. Releasing this load will void the product warranty and could result in
poor battery performance, permanent damage to Stack components, and/or injury.
Battery Modules should be positioned on flat, level ground appropriately rated for the weight of
the Module.
Battery Modules must not exceed fifteen (15) degrees of tilt angle for installation.
Do not stack Battery Modules on top of each other.
5.3 Battery Module Electrical Interfaces and Connections
J1
Module Negative (-) Battery Terminal
P/N: Amphenol RADLOK RL9-100-101
Mating P/N: Amphenol RADLOK Tubular Connector Black RL0-100-1-
xx
BK
PIN #
NAME
WIRE COLOR
DESCRIPTION
1
BATT-
Black
Module Battery Negative Terminal
J2
Module Positive (+) Battery Terminal
P/N: Amphenol RADLOK RL9-100-101
Mating P/N: Amphenol RADLOK Tubular Connector Red RL0-100-1-
xx
RE
PIN #
NAME
WIRE COLOR
DESCRIPTION
1
BATT+
Red
Module Battery Positive Terminal
