AQUILO CCT1500, Руководство оператора

Страница: 15 / 25

5. Press the power button to turn on the Control Unit. Hold down the water pump
power button for 3 seconds to turn on the cryo-therapy controls. Use the
[+]
and [ – ] buttons to increase or decrease the duration of the treatment session.
Select the [Pulse] button if the ‘pulse’ functionality is desired during this
treatment session.
6. Place the user’s legs into the Boots, sliding each Boot up their leg until their heel
is squarely at the bottom. Completely zip the Boots and ensure the user is seated
comfortably prior to starting the treatment.
7. Tap the water pump power button to start the flow of water to the pads.
8. Add ice throughout the treatment as necessary to maintain the target
temperature.
9. At the completion of the treatment session, wait approximately 30 seconds
before disconnecting water tubing to let the water drain out of the pads and
back into the reservoir.
10. Press the power button to tun off the unit. Unplug the power supply and water
tubes from the control unit.
11. With the unit placed securely at the edge of a sink or other drain, untwist a drain
cap on the side of the unit to let the water flow out of the reservoir. Replace the
drain cap after the water has been drained.
Storing the CCT1500 System:
When preparing to store the unit after use:
•
Drain the reservoir as completely as possible and wipe off any excess
water before storing the Control Unit.
•
Whenever possible, store the tank with the lid open to allow the system to dry.
•
Deflate the Compression Boots as completely as possible by unplugging the air
tubes and gently pushing the air out.
•
Store the system indoors
•
Avoid leaving the Control Unit or Compression Boots in extreme conditions such
as direct sunlight or extreme hot or cold temperatures
Cleaning the CCT1500 System: