AQUILO CCT1500, Руководство оператора

Страница: 14 / 25

Compression Treatment:
1. Connect the air tubing from the Control Unit to each plug on the Compression
Boots. Use the notch on the plugs to properly orient the connectors. You should
hear a click from each connector when they are properly attached.
2. Connect the AC adapter to an electrical outlet and insert the plug into the power
port on the Control Unit. Skip this step when operating the system via battery
power.
3. Press the power button to turn on the Control Unit. Use the lower panel on the
Control Unit to program the compression settings for the treatment session.
Select the desired compression mode by tapping the
[SET] button and cycling
through the options using the [+] and [ – ] buttons. Tap the [OK] Button again
and choose desired pressure by increasing the decreasing the pressure with the
[+] and [ – ] buttons. Tap the [OK] button again and set the desired session
time by increasing and decreasing the duration using the [+] and [ – ] buttons.
Tap the [OK] button again to finalize selections.
4. To prevent compression of sensitive areas or focus the treatment on a specific
area, compression chambers can be excluded from the program. To exclude a
chamber, select that chamber on the chamber selection diagram.
5. Place the user’s legs into the Boots, sliding each Boot up their leg until their heel
is squarely at the bottom. Completely zip the Boots and ensure the user is seated
comfortably prior to starting the treatment.
6. Tap the [Start/Pause] button to begin the compression treatment.
7. After completion of the treatment, press the power button to turn off the system.
Unplug the power supply and air tube from the Control Unit.
Cryo-therapy:
1. Open the reservoir door using the finger groove in the door.
2. Add water to the appropriate fill line inside the tank (1 or 2 users). DO NOT
overfill the water. Fill the remaining reservoir space with ice. Close the reservoir
door completely.
3. Connect the water tubing from the Control Unit to the water pads in the Boots.
You should hear a click from each connector when they are properly attached.
4. Connect the AC adapter to an electrical outlet and insert the plug into the power
port on the Control Unit. Skip this step when operating the system via battery
power.