Aquatronica evolution ACQ110, Инструкция по эксплуатации

Страница: 39 / 60

39 - 60 IsACQ110C-0 (ENG) Rev.230708-0
XY Program Link Settings
Example 2 (for all other sensors)
1) Indicates the sensor to define as a variable, selectable using the

keys.
2) Indicates the condition necessary for starting the program (selectable using the

keys); the
following values can be used:
- Greater than the reference value (>) or greater than or equal to the reference value (>=)
- Less than the reference value (<) or less than or equal to the reference value (<=)
3) Indicates the type of reference to use, selectable using the

keys, from two possible op -
tions:
- Reference expressed as a fixed value
- Reference expressed as a modifiable curve; in this case press “Enter” on the /\/\/\/\ symbol to
access the curve and change it as needed.
4) Indicates the programmable hysteresis; this value will be positive or negative depending on
the entered condition.
Variable 1
Sump 1 level =
3
1
Ref.
LEV1
2
Example 1 (for level and water leakage sensors only)
1) Indicates the sensor to define as a variable, selectable using the

keys.
2) Indicates the condition necessary for starting the program (read-only).
3) Indicates the reference value.
4)Indicates the program’s minimum run time (expressed in seconds); the value entered using the

keys must be lower than the value entered in the “Max. Time” field.
4
Minimum time: 5 sec.
2
1
Variable 2
Density >=
Ref. 1024,5
+ 0,5
4
3
Variable 2
Density >=
Curve
+ 0,5
/\/\/\/\
2
1
4
3