CAMERA PREPARATION AND INSTALLATION
1.
Turn the camera Power switch to the ON position before closing the Housing.
2.
Set the Focus Mode Selector on the lens to the proper setting AF or MF if using a focus gear
3.
Important
Note: Small “D” Clips and strap attachments that are used for the camera strap must be removed
or moved out of the way before closing the housing.
4.
Carefully place the camera on the saddle and ensure the camera is properly installed and aligned as follows:
A)
The camera is properly aligned and secured against rotation or movement. See picture A
B)
Align the Tripod Socket of the camera with the mounting screw. Tighten the mounting screw
securely with a coin or screw driver, while ensuring that the camera position is not altered.
5.
Finally, connect the trigger release cable to the side of the camera in the remote cable socket of the camera.
(See
photograph)
Picture
A:
alignment
pin
Picture B: Trigger release cable position
CLOSING OF THE HOUSING
Once the camera is secure on the saddle inside the front half of the housing, simply:
1.
Slide the housing flash cable connector onto the hot shoe
base of the camera. (See picture C)
2.
Confirm that the On/Off lever is in the ON position
Picture
C:
flash
cable
connector
